Home > News > Content

Getting Ready For A Car Radiator Installation

Dec 17, 2016

Getting ready for a car radiator installation job is shown below the content, all to learn.

1. out of the box should be checked before packing is intact, radiator nameplate specification parameters, each attachment that comes with the full range.

2. carefully check the radiator there is no deformation or damage during transport, solid pieces are loose or have fallen off, impellers with collision phenomena, and check on the fan coil parts. If anomalies are found, should be repaired before use.

3. measured with a 500V Megger radiator shell and insulation resistance of the motor windings, their value should be greater than 0.5 megohm, otherwise the motor winding Zang, drying, drying temperature must not exceed 120 degrees.

4. ready to install the heat sink required for materials, tools and venues.

Everyone in the car radiator before installation, be sure to do preparatory work and improve efficiency.